
Bathroom care
How to keep a glass shower clean
Squeegee the glass after every shower, towel-dry the hinges and clamps, and wash the panels once a week with mild detergent on a microfibre cloth. The routine matters in the GTA, where tap water is moderately hard to hard: Toronto averaged 119 mg/L in 2025 and Vaughan 128 mg/L in mid-2026, so every drop left to dry leaves a ring of mineral. Coated glass sheds water faster but still needs the squeegee, and no shower glass tolerates abrasive powders or scrapers.
Why shower glass spots so quickly in GTA homes
Hard water is the reason. When a droplet evaporates, its dissolved calcium and magnesium stay behind as a white ring. A fresh ring wipes off; rings layered over months harden into scale, and glass left that way for years can stain for good.
York Region classes 61 to 120 mg/L of calcium carbonate as moderately hard, 121 to 180 as hard and anything above 180 as very hard. It notes there are no known health effects from hardness; the cost shows up as scale on glass, chrome and shower-head nozzles.
| Area | Hardness | Reported by |
|---|---|---|
| Toronto | 119 average, range 115 to 122 | City of Toronto, 2025 drinking water analysis |
| Vaughan, including Woodbridge and west Thornhill | 128 | York Region, 2026 second-quarter average |
| Markham, including east Thornhill | 126 | York Region, 2026 second-quarter average |
| King City | 131 | York Region, 2026 second-quarter average |
| Nobleton | 264 | York Region, 2026 second-quarter average |
What to do after every shower
Remove the water before it dries; nothing else matters as much. The National Glass Association's design guide for frameless enclosures recommends frequent squeegeeing with a non-metallic squeegee followed by a soft cloth, and Fleurco, a Canadian shower door maker, tells owners of its protected glass to squeegee dry after each use.
- Pull the squeegee top to bottom. Start at the top corner farthest from the door, work down in overlapping strokes and wipe the blade between passes. Finish with one horizontal pull along the bottom edge, where water collects.
- Towel-dry the hardware. The NGA guide notes that hinges and clamps dried after every use are less likely to need a soap wash later.
- Run the exhaust fan to cut the condensation on both faces of the glass; the bathroom exhaust fan guide covers sizing.
A weekly wash, and descaling without damage
Once a week, wash the glass with a mild detergent on a damp microfibre cloth, rinse and squeegee dry; that is EnduroShield's routine for coated glass and it suits bare glass too. For hardware that has not been dried daily, the NGA suggests mild soap and warm water on a soft cloth, then a rinse and a dry.
Descaling is where the advice splits. Fleurco recommends one part vinegar to four parts water for its protected glass, and EnduroShield suggests vinegar about weekly where water is very mineral-rich. The NGA, by contrast, lists acidic and vinegar-based cleaners among products to avoid because they can damage metal hardware. So put diluted vinegar on a cloth rather than spraying the enclosure, keep it off hinges and clamps, rinse and dry. If your glass came with a care sheet, that sheet wins.
Keep vinegar off stone as well. The Natural Stone Institute warns that lemon, vinegar and other acids etch calcareous stone such as marble, limestone and travertine, so a rinse running down a marble wall or curb will mark it.
| Task | How often | Use | Keep it away from |
|---|---|---|---|
| Squeegee the glass | After every shower | Non-metallic squeegee, then a soft cloth | Nothing; this is the main defence |
| Dry hinges, clamps and handles | After every shower | A dry towel | Abrasive cloths |
| Wash the glass | Weekly | Mild detergent on damp microfibre, clean rinse | Scouring pads and powders |
| Wash the hardware | Weekly, if not dried daily | Mild soap, warm water, soft cloth | Any abrasive cleanser |
| Descale the glass | When a film survives the weekly wash | Diluted vinegar on a cloth, if your glass maker allows it | Hardware, marble, limestone and travertine |
Factory-applied and aftermarket glass coatings
A coating makes water bead and run off instead of drying in a sheet. The NGA describes two routes: glass makers supply float glass with coatings that survive tempering, and fabricators or installers apply coatings after tempering. Fleurco treats most of its doors with its Microtek coating; EnduroShield is sold factory-applied, as an on-site service or as a do-it-yourself kit, and its accelerated testing simulated ten years of cleaning.
A coating does not retire the squeegee; Fleurco still asks for one after each use. Coatings also carry cleaner restrictions: the NGA warns that unapproved products can damage them, and EnduroShield names gritty, highly acidic and alkaline cleaners, including cerium oxide, as harmful. Keep the care sheet with your warranty papers, and if water stops forming tall, separate beads, check whether the maker allows the coating to be renewed.
Cleaners and tools that scratch or etch shower glass
Most lasting damage comes from attacking spots too hard. Avoid these, drawn from the NGA guide, the glass makers and the Natural Stone Institute:
- Abrasive or soft-abrasive powders and liquids.
- Steel wool, steel or Teflon pads, metal brushes and scrapers.
- Bleach and bleach-based cleaners.
- Acidic or vinegar-based cleaners on hinges, clamps and handles.
- Cerium oxide and other polishing compounds on coated glass.
- Rust removers and toilet bowl cleaners, many of which contain trace hydrofluoric acid; it attacks silicate minerals and is the acid used to etch glass.
Renovation choices that cut the cleaning
A single fixed panel has fewer edges, hinges and seals to wipe than a door, and frameless glass has no bottom track for scale to build in; frameless vs framed shower doors covers the trade-offs. A shower head aimed at tile rather than glass keeps most spray off the panel. Where water is very hard, as in Nobleton at 264 mg/L, a whole-house softener is worth pricing; York Region explains that softeners swap calcium and magnesium for sodium or potassium.
Questions
Can I use a razor blade on hard water spots?
Not on glass you want to keep. Fleurco rules out scrapers, and on coated glass a blade can strip the coating along with the scale. Soften the deposit with a descaler your glass maker approves and wipe with microfibre; years-old staining calls for professional restoration.
Are daily shower sprays safe on coated glass?
Some are. EnduroShield's accelerated test of six popular cleaners, including a daily shower spray, found no harm to its coating when the glass was rinsed afterwards. Other coatings have other rules, so check yours, and keep squeegeeing.
How can I tell if my shower glass already has a coating?
Splash it. Coated glass throws water into tall, separate beads that run off quickly, while bare glass holds a flatter film. The supplier's paperwork should name the coating and the cleaners it accepts.
Why is my glass still cloudy after a deep clean?
If the haze survives a proper descale, the surface may be etched or permanently stained from scale left for years. The options are professional restoration, which coating makers such as EnduroShield offer through applicators, or a new panel.
Sources and further reading
- City of Toronto: Drinking water analysis summary 2025 (hardness)
- York Region: Drinking water quality and monitoring (2026 Q2 hardness)
- National Glass Association: Frameless Shower Enclosures Design Guide (DG02-21)
- Fleurco: Shower enclosure FAQ (glass care and Microtek coating)
- EnduroShield: Care instructions
Checked November 19, 2026. Codes, by-laws, prices and product specifications change; confirm with your municipality, condo corporation or supplier before you build.
Keep reading
Related guides




