Renovations

Guides

Blue shaker island drawers with long pulls in afternoon light in front of tall windows

Condo plumbing

Condo plumbing: risers, shut-offs and leaks

In a condo, water reaches your suite through vertical risers shared with the units above and below, passes a shut-off valve where it enters your unit, and leaves through shared drain stacks. Risers and stacks are usually common elements; the pipes and fixtures inside your unit are generally yours to maintain. When a leak reaches a neighbour, the Condominium Act has the corporation repair damage to the standard unit, but you can be charged up to its insurance deductible if you caused it. Find and test your shut-off before any renovation starts.

By the Purple Kitchen & Bath team · Updated · 5 min read · Photo: a Purple Properties project

How water moves through a condo tower

Water climbs the building in risers, branches off on each floor into the suites, and returns down shared drain stacks, so every suite in a vertical line shares the same pipes. The Ontario Building Code sets out the valves that make that arrangement manageable: a riser serving more than one dwelling unit needs a shut-off valve at its source of supply, every toilet needs a shut-off on its supply pipe, and in a residential building with more than one dwelling unit a shut-off valve must be installed where the water supply enters each unit, so one suite can be shut off without interrupting the rest of the building.

Tall buildings also have to manage pressure. Where static pressure at a fixture may exceed 550 kPa (about 80 psi), the code requires a pressure-reducing valve to bring it down to that limit, which is why towers are fed through pressure-controlled zones rather than one long column of water.

The parts of a condo plumbing system and who usually looks after them (confirm in your declaration)
PartWhat it doesUsually maintained by
Supply risersCarry hot and cold water vertically past every floor in the stackThe corporation, where the declaration makes them common elements
Drain and vent stacksCarry waste from every suite above down through the buildingThe corporation, where they are common elements
Suite shut-off valveIsolates your unit's water supply onlyDepends on the declaration's unit boundaries; ask management
Branch piping inside the unitRuns from the shut-off to your fixturesThe owner, who maintains the unit under section 90
Fixture stops and supply hosesIsolate a single toilet, faucet, dishwasher or washerThe owner
Pressure-reducing valvesKeep static pressure at fixtures at or below 550 kPaThe corporation, as part of the building's system

Find and test your suite shut-off before demolition day

Locate the valve, close it, open a faucet and confirm the flow stops completely before anyone cuts a pipe. In many suites the valve sits behind an access panel near the riser: in a ceiling, in a closet, behind a bathroom wall or in the laundry cupboard. If you cannot find it, ask management before work is booked, not on the morning of demolition.

Older valves are the weak point. A multi-turn valve that has not been closed in years can seize, or close only partway and let water weep past. If it will not hold, replacing it usually means the building shutting off the riser, which cuts water to every suite on that stack and has to be booked with management and announced to the neighbours. While the riser is off, replacing the suite valve and the fixture stops with quarter-turn ball valves is cheap insurance.

Keep every access panel accessible after the renovation. On reasonable notice the corporation may enter a unit at any reasonable time to carry out its duties (section 19 of the Condominium Act), and in an emergency staff need to reach that valve quickly. Tiling over an access panel or building millwork in front of it turns a five-minute shut-off into a demolition job.

Water hammer: why condo pipes bang, and what fixes it

Water hammer is the bang or shudder you hear when flowing water is stopped suddenly, typically by a dishwasher, washing machine or toilet valve closing fast. The pressure wave can do more than make noise: repeated surges strain joints and can, in the worst cases, break pipes or fittings.

The Ontario Building Code requires the water distribution system to be protected from the adverse effects of water hammer, and factory-built water hammer arresters must conform to ASSE 1010. In a renovation, the practical fixes are:

  • Arresters at quick-closing appliances. Fit them at the dishwasher and washing machine connections, where most banging starts.
  • Secure the pipes. Pipes strapped firmly inside the wall knock less than pipes left loose against framing.
  • Check the pressure. If the banging is new and building-wide, tell management; a pressure-reducing valve that is failing is a building issue, not yours to adjust.

Leak detection worth adding while the walls are open

Most condo leaks start at a handful of predictable points, so a few devices placed there catch most of the risk. Adding them during a kitchen or bathroom renovation costs little, because the cabinets and walls are already open.

Leak protection for a condo kitchen or bathroom
DeviceWhat it catchesWhere it goes
Battery or wired water sensorsWater on the floor from a failed hose, trap or sealUnder the kitchen sink, behind the dishwasher and fridge, beside the toilet, under the vanity
Automatic shut-off valveA leak that keeps running while you are awayOn the suite supply downstream of the shut-off, wired to the sensors; confirm with management first
Braided stainless supply linesBurst rubber hosesToilet, faucets, dishwasher and fridge water line
Drip panSlow leaks from a washer or dishwasherUnder appliances where the layout allows
A continuous waterproofing membraneWater getting past tile and groutThe whole shower area and, ideally, the bathroom floor; see shower waterproofing systems

Who pays when a leak reaches the unit below

The Condominium Act sets a default split that your declaration can change, so read both. By default the corporation repairs the units and common elements after damage (section 89), but that obligation does not extend to improvements, judged against the standard unit; each owner maintains their own unit, including repairs after normal wear and tear (section 90); and the declaration may shift repair after damage to owners (section 91). If the leak was caused by an act or omission of you, your tenant or someone living in your unit, section 105(2) adds the lesser of the repair cost and the corporation's insurance deductible to your common expenses, and a by-law under section 105(3) can extend that to leaks nobody caused.

Common condo leak scenarios under the Act's defaults
ScenarioWhat usually followsSections
A supply line under your vanity bursts and water reaches the suite belowThe corporation repairs both units to the standard unit; you may be charged up to its deductible89, 105(2), 105(3)
A shared riser leaks inside your bathroom wallA common-element repair; the corporation opens the wall and fixes the riser89, 90
Your upgraded tile and millwork are damagedImprovements above the standard unit fall to your own insurance89(2), 99(4)
You leave a known drip unrepaired and it threatens other unitsThe corporation may do the work and add the cost to your common expenses92(3), 92(4)

Plumbing changes that need a permit and a booking

In Toronto, Toronto Building requires a permit to install or modify plumbing systems, while repairing and replacing plumbing fixtures does not need one. Swapping a faucet or toilet in place is a fixture replacement; moving a sink, adding a fixture or rerouting a drain is a modification.

Moving a drain in a condo also means working through the concrete slab, which brings scanning, coring approval and the suite below into the project; the condo tub to shower conversion page walks through that. Whatever the scope, the building will want any water shut-off booked in advance, and the Condominium Authority of Ontario advises owners to use licensed plumbers, electricians and contractors.

Questions

Where is the water shut-off in a typical condo suite?

Usually behind an access panel close to where the riser enters the suite, often in a ceiling, a closet, a bathroom wall or the laundry cupboard. Each fixture should also have its own stop. If you cannot find the suite valve, ask management; they may have drawings showing it.

Why does a renovation in one suite sometimes shut off water to the whole stack?

When the suite valve will not hold, or the work connects to the riser itself, the only safe way to work is to shut the riser down. That cuts water to every suite on the line, so buildings schedule it in advance and post notice.

Does the corporation's insurance cover my neighbour's upgraded floors after my leak?

The corporation's policy covers damage to the units up to the standard unit. Upgrades above that, in your suite or the neighbour's, are each owner's improvements to insure. You may also be charged up to the corporation's deductible; see condo renovation insurance and liability.

Should I add a water hammer arrester when I replace the dishwasher?

If the pipes bang when the dishwasher or washer shuts off, yes. The building code requires protection against water hammer, and an arrester conforming to ASSE 1010 fitted at the appliance connection is the standard fix.

Sources and further reading

  1. O. Reg. 163/24: Building Code (Ontario), Part 7 Plumbing (7.6.1.3, 7.6.1.9, 7.6.3.3)
  2. Condominium Act, 1998, S.O. 1998, c. 19 (sections 19, 89 to 92, 105)
  3. Condominium Authority of Ontario: Repairs and maintenance
  4. City of Toronto: When do I need a building permit
  5. Water hammer (Wikipedia)

Checked November 19, 2026. Codes, by-laws, prices and product specifications change; confirm with your municipality, condo corporation or supplier before you build.

Plan your condo renovation

Initial consultations are complimentary. Jordan Duda, our client care and lead estimator, is usually your first point of contact.